I finally got my plane in the air, lifting off at 7:50AM this morning.
OAT was about 40F.  Flew for about 20 minutes, did one stall and landed
to check everything.

I bobbled around a bit on take off getting used to the control feel.
Landing was uneventful.

I will need to do some work on cooling as I expected. The oil cooler
location is poor with not enough room behind it and oil temps are
running about 10-15 deg warmer than the water.  Both are too high for
summer time flying.  Max oil temp was about 220F, so it was higher than
I wanted to see.  I also want to recheck the calibration on the sensors
just to make sure I didn't mess that up.

Another rotary is now flying at least a little.  Send me one of those
buttons Tracy! :)

Bob White

-- N93BD - Rotary Powered BD-4 - http://www.bob-white.com
First Flight:  11/23/2006 7:50AM Cables for your rotary installation - http://www.roblinphoto.com/shop/

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:  http://mail.lancaironline.net/lists/flyrotary/