Received-SPF: none
 receiver=logan.com; client-ip=216.211.128.139; envelope-from=joeh@PilgrimTech.com
From: "Joe Hull" <joeh@PilgrimTech.com>
To: "'Rotary motors in aircraft'" <flyrotary@lancaironline.net>
Subject: RE: [FlyRotary] N93BD BD-4 First Flight
Date: Thu, 23 Nov 2006 11:17:11 -0800
Message-ID: <005501c70f33$fa6c51a0$8802a8c0@Pilgrim10>
MIME-Version: 1.0
Content-Type: text/plain;
	charset="US-ASCII"
Content-Transfer-Encoding: 7bit
In-Reply-To: <list-1597269@logan.com>
Thread-Index: AccPK5rkBAodlmarRbSPPU/ArKfmnAAB/keA

Hey Bob, CONGRATULATIONS!!!! Little or long by the clock - that first flight
will live with you for a lifetime!  

Great work, and your now 50% done with your airplane :) 

Regards, 
Joe Hull
Redmond/Seattle WA, Cozy-Mazda Rotary 69hrs

> 
> I finally got my plane in the air, lifting off at 7:50AM this morning.
> OAT was about 40F.  Flew for about 20 minutes, did one stall and landed
> to check everything.
> 
> I bobbled around a bit on take off getting used to the control feel.
> Landing was uneventful.
> 
> I will need to do some work on cooling as I expected.  The oil cooler
> location is poor with not enough room behind it and oil temps are
> running about 10-15 deg warmer than the water.  Both are too high for
> summer time flying.  Max oil temp was about 220F, so it was higher than
> I wanted to see.  I also want to recheck the calibration on the sensors
> just to make sure I didn't mess that up.
> 
> Another rotary is now flying at least a little.  Send me one of those
> buttons Tracy! :)
> 
> Bob White
> N93BD - Rotary Powered BD-4 - http://www.bob-white.com
> First Flight:  11/23/2006 7:50AM
> Cables for your rotary installation - http://www.roblinphoto.com/shop/