Hi Bill,

At least some of the K&N filters have holes in the "nut" on the bottom
of the can that can be used to wire tie it.  The hole can be seen in
the close up photos of the K&N HP-3001 and HP-3002 on the Summit web
site.  The HP-3001 is a replacement for the PH8A.  I'm not sure how
long the PH8A is.  You might want to look at the HP-2004 also.

Bob W.

On Thu, 25 May 2006 09:41:09 -0400
"Bill Bradburry" <bbradburry@allvantage.com> wrote:

> How do you go about wire tying an automotive oil filter?  Are there
> filters available that can be wire tied?  My remote oil filter mount is
> 3/4-16 thread size and is designed for the Fram PH8A type filter.  I
> notice that aircraft filters have a male and not female fitting.  I
> could remove the male fitting from my mount, but I don't think the
> aluminum threads would hold up well if they were subjected to frequent
> removal/install.
>
> What is a best practices solution?
>
> Bill Bradburry
>
>
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/