On Sat, 7 Jan 2006 22:32:26 -0600
"Russell Duffy" <13brv3@bellsouth.net> wrote:

> (I need to start reading some of the EC2 and EM2 instructions.)  I made no
> attempt to set mixture or anything, and all of the sensors are using the
> default settings.  The actual values may change as I get calibration data.
> I do have Tracy's latest self adjusting mixture feature, and it did seem
> like the engine smoothed out as it ran.
>
>  
> Hi Bob,
>  
> Glad to hear your engine is running, and all the parts are still attached
> :-)  
>  
> As for autotune, if you haven't read the instructions yet, I guarantee you
> aren't using autotune yet.  I'm looking forward to trying it, and might even
> do that tomorrow.  I'm going to run the engine some more, and try to make
> some sense of the rattle zones on the redrive.  
>  
> Cheers,
> Rusty (mammoth full wall of custom sized shelves from hell installed)
>  
> PS- Thanks Dale for the Gmail invite.  
>
>
Hi Rusty,

I'm going to have to talk to Tracy about that.  I twisted his arm and
made him send me the instructions for modifying the PC board for the
new chips he's using.  (Didn't want to give up the EC2 in case I needed
it.)  I don't think I have any instructions for using autotune, so
maybe I'm not using it.  At one point I did flip over to the B
controller.  Engine didn't miss a beat.

Bob W.


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/