----- Original Message -----
Sent: Saturday, January 07, 2006 6:11
PM
Subject: [FlyRotary] Re: Renesis
Horsepower Chart
Ed,
This is the only chart I have seen that shows flywheel
HP. I have seen two or three rear wheel dyno charts that show between 190 and
204 hp. These where with aftermarket exhausts and intake filter. The 204hp was
running a Mazdasport Interceptor ECU. This dyno chart did not show rpms but
showed MPH. I found one chart that showed peak hp at 178 at 7300 rpms. This
was a stock RX8 no mods at 500ft elevation. Racingbeat's test show 8 hp
improvement by removing the catalytic converter regardless of muffler and 2 hp
by improving the intake. So 204hp seems like a reasonable
number with modified exhaust, intake and an aftermarket ECU.
Any swags as what the HP loss is to rear wheels?
Bobby
(making cardboard intake)
Correct in what sense, Bobby?
It looks similar to charts I saw early on by Mazda
showing the output of the Stock Renesis to be 250HP. The trouble
began, when other folks started putting the
Renesis on dynos and could not get that much
power. Mazda later revised its HP for the Renesis downward to the 235 HP
level at 9000 rpm.
Remember you can peak and tweak a dyno installation to
get numbers that you would not normally see in operational usage. Others
out there with real dyno experience can verify this.
FWIW
Ed
----- Original Message -----
Sent: Friday, January 06, 2006 2:35
PM
Subject: [FlyRotary] Renesis Horsepower
Chart
Can anyone
verify that this chart is correct or not?
Bobby
--
Homepage: http://www.flyrotary.com/
Archive
and UnSub: http://mail.lancaironline.net/lists/flyrotary/