George,
Mistral's PSRU is a custom made gearset. Which can be done of course,
it's just hard to justify the expense unless you sell many of them! A very
nice looking job BTW though expensive. Some one needs to design a new
lower cost (electric CS) prop. Other wise the Mistral unit looks good for
the 10 despite it's high initial cost.
Bill Jepson
-----Original
Message-----
From: george lendich <lendich@optusnet.com.au>
To:
Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Fri,
6 Jan 2006 09:18:16 +1000
Subject: [FlyRotary] Re: Dodge vs Ford
Ken,
Good info - keep it coming!
Now just find me an overdrive, straight cut
gears (NEW) with a 2.5:1 ratio, steel planet with gears running on
needle bearings, with a RH Turning prop.
That shouldn't be too hard - I'm seriously
looking to have one made!
I wonder where Mistral gets theirs
from?
George ( down under)
Here is is an email that was sent to
me to forward to you all from a friend of mine that talked me out of
building a C-6 based 3.17 ratio gearbox and talked me into using the 3.21
Dodge gears.
He is not on this list but you may have
heard of him as he is on the rotary roster as he is building a Coot with a
rotary and he is using one of my 2.95 belt drives and he should be flying
it this summer.
He thinks I am nuts going away from the
belt drive that I have put 900 trouble free hrs on and says he will stick
with the belt even though works on transmissions for a
living.
Ken Welter
Date: Wed, 04 Jan 2006 06:47:42 -0800
(PST)
From: Arnold <vwsandndirt@yahoo.com>
Subject: Re: Fwd
Re: [FlyRotary]Soapbox Warning! PSRU
Ratios
X-Originating-IP: [66.218.79.59]
To: Ken Welter
<rotary.coot@verizon.net>
One thing I can tell you is
that in the last 15 plus years that I have dealt with planetaries,
I still see Ford sun gears coming apart in 80% of units I take apart and
I have yet to find a bad Dodge sun gear with the exception on total
planet meltdown due to a plugged trans cooler. I am not an
engineer, just an observer and a very qualified transmission
expert.
Another thing I can tell you is that it
was not the amount of pinion gears that were put into the Ford planets
that made it better, it was the change from aluminum to steel to keep
the splines from stripping out. Also, the Ford planets are only
being used (loaded) during up shifts and the Dodge planet set in
question is being used during the long period of time the truck is
towing the trailer down the highway in overdrive.
Good luck with your ratio debate and I
hope this info is of help.
Arnold Norton ASE
certified
American
Transmissions