|
Message
I need to know the distance from the engine bellhousing surface
to where the Spinner back plate will fit on Tracy's RD-1C drive.
Hi
Bill,
I just walked out and
measured the RD-1C drive that's mounted on the single rotor, and found the
distance to be 14.75". This is from the surface of the rear housing where
the bellhousing would normally bolt, to the face of the prop hub.
Can't help you with the
email question. I only wish I understood that stuff better. I have
similar problems with the list. Sometimes my messages appear hours later,
and sometimes they appear twice.
Cheers,
Rusty (RV-8, the easy
way)
|