|
since I am forced to sell all my rotary
project I would like to recoup my cost for a remote oil mount. I paid
someone(Al?) on the list $100 for just one of these blocks. for this
application we machined a press fit separation plug and then fabricated the
second block. there is an 1/8" NPT tap for a sensor also. the oil
filter holder goes with my 20B engine and is not for sale. My guess is
that this set-up is the same as the 13B. I was going to use a piece of AL
angle to mount the filter block, perhaps off the PSRU. so, make an
offer.
|