My Renesis was built using the same O-ring kit that RWS sells for the
earlier 13B. TES inner coolant O-ring but Viton oil seal rings.
Works just fine.
Just read the Car & Driver article on long term test of RX-8.
They saw the same long break-in period on the engine that I did.
Compression was terrific from first run on but the power increased slowly over
time. The CD car was significantly faster in the 1/4 mile after 40,000
miles than when new. I still don't know why this should be. The
slightly wider side seals and exhaust shield on the rotors would not
seem like they would cause this much difference.
Tracy (off to Colorado for 3 weeks)
----- Original Message -----
Sent: Friday, September 02, 2005 1:32
AM
Subject: [FlyRotary] Re: "O" rings/
Exhaust flanges
George,
Now we need one of our Renesis engine builders to step
up and prove
that the coolent seals fit their rotor housings.........Did you purchase
TES
rotor seals from Creavey for your Renesis rotors ?
--
Kelly Troyer
Dyke
Delta/13B/RD1C/EC2
--------------
Original message from "George Lendich" <lendich@optusnet.com.au>:
--------------
Lynn,
I would say my "O"rings fit pretty well and
that's the Cosmo Rotor Housing - see photo.
--
Homepage:
http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net/lists/flyrotary/