Welcome Jim,

You've found the right place for rotary info.  Of course we're both on
the other list (No not THAT other list) for BD-4 info.

Bob W.  (You'll figure out what "the other list" usually means around
here soon enough.)

On Wed, 8 Jun 2005 06:48:27 -0500
"James Calamon" <n5658z@gvtc.com> wrote:

> Hello everyone, I'm the new kid on the block and seriously looking at rotary power for my BD-4 project (check the link below). I need some help in getting started on information that I should bone up on before jumping into the morass of rotary engine building. I ordered the book on rotary conversions by Tracey Crook as a start, but would like input from experienced builders as to other recommended reading and reference material (i.e. books and web sights).
>
> Best Regards
>
> Jim Calamon
> N5658Z New Braunfles, Texas (BAZ)
> "People may fail many times, but they become failures only when they begin to blame someone else" - Unknown
>
> http://gvtc.com/~n5658z/
>
>
>


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
Prewired EC2 Cables - http://www.roblin-photo.com/cable/