Him,

   Unless you are going to buy a pre-built engine from a major
builder, get the Bruce Turrentine tape (also available from
Tracy.)  

   Come to think of it, even if you don't intend to take
the engine apart, the tape will help you better understand
the engine, get it anyway.

Dale R.
 
> From: "James Calamon" <n5658z@gvtc.com>
> Date: 2005/06/08 Wed AM 07:48:27 EDT
> To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
> Subject: [FlyRotary] New kid on the block.
>
> Hello everyone, I'm the new kid on the block and seriously looking at rotary power for my BD-4 project (check the link below). I need some help in getting started on information that I should bone up on before jumping into the morass of rotary engine building. I ordered the book on rotary conversions by Tracey Crook as a start, but would like input from experienced builders as to other recommended reading and reference material (i.e. books and web sights).
>
> Best Regards
>
> Jim Calamon
> N5658Z New Braunfles, Texas (BAZ)
> "People may fail many times, but they become failures only when they begin to blame someone else" - Unknown
>
> http://gvtc.com/~n5658z/
>
>
>
>