Hi Georges,

Quite possibly.  I haven't looked at the EM2 wiring very closely yet to
see what would be useful.

Bob W.

On Thu, 26 May 2005 18:52:51 -0700 (Pacific Standard Time)
"Echo Lake Fishing Resort (Georges Boucher)" <echolakeresort@telus.net>
wrote:

> Bob Are you considering doing the harness for the EM-2 as well?
> Georges B.
>  
> -------Original Message-------
>  
> From: Rotary motors in aircraft
> Date: 05/26/05 02:55:46
> To: Rotary motors in aircraft
> Subject: [FlyRotary] Re: Prewired EC2 Cables
>  
> Actually, yes... I would consider it... more than anything else because I
> HATE" soldering those 15 and 37 pin connectors.
>  
> In my case, I would have to get back to you on wire lengths, because I
> intend to use Cannon Plugs at the Firewall to be able to remove/install the
> harness for engine removal/swaps. On the velocity, we will have the Engine
> Controller on the aft firewall, inside the passenger compartment. We do not
> have the EM2 (havent ordered it yet) but I understand now that there is not
> a "separate" brain anymore, and that would be a long run from the front
> panel to the aft bulkhead.
>  
> Dave
> League City (Houston), TX
>
> Bob White wrote:
>
> I'm contemplating offering prewired cables for Tracy's EC2.  I've been
> in the electronics field for over 40 years so soldering and cabling are
> easy for me.  
>
> I would prewire the 15 and 37 pin connectors to your specified length.
> Other wires would be long enough to be cut off and terminated by you.
> Wires would be tefzel (M22759/16) or better and each wire would be
> clearly marked.  Everything would be done to the specs in Tracy's
> manual.
>
> Using my installation as a reference, I would make the unterminated
> wires that go under the insturment panel 5 feet long and those going to
> the engine compartment 10 feet long.  Length from the 15 pin
> connector to the 37 pin connector is 36 inches.  Based on that, the cost
> would be $95 but this would be adjusted for different lenght
> requirements. These lengths should leave enough wire for most
> installations.
>
> Also, for the canard community, I would be willing to cable anything up
> to your specifications, but because of the long runs and sensitivity to
> noise I wouldn't want to gurantee sucess in using the cable.
>
> Is there any interest in such a service?
>
> Bob White
>
>  
>  


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)