|
Ed,
Did you check side clearances in the apex groove
before assembly?
George ( down under)
----- Original Message -----
Sent: Wednesday, April 13, 2005 5:15
AM
Subject: [FlyRotary] The Final? story on
the engine problem
Second set of photos
Photo Apex Scrapes shows that the ejected apex
seal piece probably made it around the chamber a couple of times, one
impression looks to be smaller than the width of the ejected piece - so
perhaps it broke up further in its round.
Photo Apex Slot Peened shows that the 2nd apex
seal of #1 rotor that would not move up and down - clear why, now. The
departing piece peened over the slot and froze the seal in its slot. I
had to pry the opposite end of the seal up to the position you
see.
>> Homepage:
http://www.flyrotary.com/
>> Archive:
http://lancaironline.net/lists/flyrotary/List.html
|