Received-SPF: pass
 receiver=logan.com; client-ip=24.25.9.100; envelope-from=eanderson@carolina.rr.com
Message-ID: <000401c53f9b$bf04f0e0$2402a8c0@edward2>
From: "Ed Anderson" <eanderson@carolina.rr.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
References: <list-866583@logan.com>
Subject: Re: [FlyRotary] Re: The Final? Story on the Engine problem
Date: Tue, 12 Apr 2005 16:10:58 -0400
MIME-Version: 1.0
Content-Type: text/plain;
	charset="iso-8859-1"
Content-Transfer-Encoding: 7bit


----- Original Message -----
From: "echristley" <echristley@nc.rr.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Tuesday, April 12, 2005 3:40 PM
Subject: [FlyRotary] Re: The Final? Story on the Engine problem


>
> >Photo  Apex Departing Slot clearly shows where the missing piece of the
> apex
>
> >seal bent over the straight edge of its slot when it departed. Apparently
>
> >when it left the clearance was getting less and the departing edge was
>
> >apparently caught between the lip of the slot and the rotor housing
forming
>
> >a flatten corner.
>
> >
>
> Ed,
>
> How well does the position of the break line up with your exhaust port?
Are
> there any tiny chips near the break that look like they may have been
around
> a while?
>
> I'm thinking of the possibility of a piece of debris chipping the seal in
> the vicinity of where it flexes as it crosses over the exhaust hole.
Stress
> riser, being the unpredicable ^%&# they are, will always give out just as
> you cross the limit of not being able to glide home.
>

A good point, Ernest, I'll have to go back out and check the pieces in
better light or better yet bring them in the house where i have a couple of
magnifying glasses.

Ed