|
Thanks Tracy,
I appreciate the response as I'm ready to order
parts.
I've also ordered a single set of your Apex Seals for my
single RX8 rotor - I have to get a cheque to Laura!
I was reading some comments on your site, which someone
kindly referred me to, about the e-shaft only inserting into the Rx8 pulley
by about 60 % of the depth of the pulley.
Question:-
If designing a single e-shaft from scratch to accommodate
the RX8 pulley ( with timing wheel) - should I allow for a longer
shaft.
TIA
George ( down under)
Assuming you have no problems mounting the wheel & sensor in the same
relative position they are on the RX-8 engine, it will work fine on any rotary
(1,2, 0r 3 rotors). You must order EC2 with the RX-8 crank sensor option
for this to work of course.
Tracy (preparing for road to go under water again)
Tracy,
Can the RX8 timing wheel and sensor be used on
the RX7 and can I use it on the single without causing other problems -
using your EMS.
George ( down
under)
|