Right on.  It says re-scheduled.  Too bad it didn't get here today.  I don't
remember when it was originally scheduled, so is it early or late?  I should
get it tested next week though.  (Rusty sent me his Craig-Davies pump to
measure on the same setup I used with the WP136's)  

The hardware store had 1 1/4 fittings and 1 1/2 fittings so I got the 1 1/4.
Maybe I can wrap enough tape around it to get a seal since the pressure isn't
much.

I bought some Earl's Pro-Lite 350 hose from Summit.  It is a nylon braid and
fits the Earl's reusable swivel ends.  It's good to 300 psi and 350 F.  It's
also a lot more flexible than the hoses I had made.  Am I going to lose much
reliability by using this instead of the stainless steel braided hose?  The SS
hose has a better pressure rating, but both are way over rated for what I need.

Bob W.

On Thu, 24 Mar 2005 20:35:33 -0600
"Russell Duffy" <13brv3@bellsouth.net> wrote:

> I received the new WP337 water pump today.  The WP136's are at the airport,
> but just looking at it, the motor is bigger in diameter and shorter.  If not
> too much goes wrong, I will make some flow measurements tomorrow.  I will at
> least get a comparison photo of the two pumps.
>
> According to UPS, you'll have another pump to test tomorrow :-)
>  
> Cheers,
> Rusty (looking forward to the results)
>
>
>
>
>
>


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)