Oops; attached the same photo
twice. Here is the intake.
Al
Al, just wondering if you could pass
on your numbers for your oil cooler installation. Do you know what size [ sqr
inch] your inlet, cooler and exit are? did you use a NACA on the bottom
side of the wing?
Jarrett Johnson
The
oil cooler core is 5.31” x 21.5” = 114 sq. in. The inlet is
1.15 x 22 = 25 sq. in. The exit is about 1.8” by 22” = 40 sq.
in.
The
inlet “duct” goes in at about a 45 degree angle, and has an airfoil
shaped “lip” along the trailing edge that extends about ½”
below the lower surface of the wing.
Photos
attached.
Al